Utax P-C3570DN Manual de usuario Pagina 149

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 255
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 148
4-76 Using the Operation Panel
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
1 In the Basic menu, press or to select IPSec.
2 Press [OK]. The IPSec screen appears.
3 Press or to select whether IPSec is enabled.
4 Press [OK]. The IPSec setting is set and the Basic menu reappears.
LAN Interface (LAN Interface setting)
Specify the settings for the LAN interface to be used. The default setting
is Auto.
1 In the Basic menu, press or to select LAN Interface.
2 Press [OK]. The LAN Interface screen appears.
The available LAN Interface are as follows:
Auto
10BASE-Half
10BASE-Full
100BASE-Half
100BASE-Full
1000BASE-T
3 Press or to select the desired LAN Interface.
4 Press [OK]. The LAN Interface is set and the Basic menu reappears.
MACAddressFilter (MAC address filtering setting)
This sets whether or not to enable MAC address filtering.
1 In the Basic menu, press or to select MACAddressFilter.
2 Press [OK]. The MACAddressFilter screen appears.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
Note LAN Interface is only displayed when the optional
network interface kit (IB-50) is installed.
Note The detailed settings for MAC address filtering are selected
using the optional network interface kit utility software.
IPSec:
a
b
1
*Off
2
On
LAN Interface:
a
b
1
*Auto
2
10BASE-Half
3
10BASE-Full
MACAddressFilter:
a
b
1
*Off
2
On
Vista de pagina 148
1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 254 255

Comentarios a estos manuales

Sin comentarios