Utax P-4030DN Manual de usuario descargar pdf (Pagina 117)

4-57

Operation Panel

This new network address section (originally part of the host address) made possible by the subnet mask is referred to as

the subnet address.

1 In the IPv4 Setting menu, press  or  to select Subnet Mask.

2 Press [OK]. The Subnet Mask screen appears.

3 Use the numeric keys or press  or  to set the subnet mask.

You can set any value between 000 and 255.

Increase or reduce the figures by pressing  or .

Use  and  to move the position being entered, which is shown

highlighted.

4 Press [OK]. The subnet mask setting is stored and the IPv4

Setting menu reappears.

Default Gateway (Gateway setting)

Gateway generally refers to a protocol conversion device used to allow networks with differing protocol systems to

interconnect.

For example, a "Gateway" device is required to connect a different closed network (using its own protocols) to the open

Internet (using TCP/IP).

By installing a gateway, the communications protocols and data display modes on different networks can be made

compatible.

On TCP/IP networks, the term gateway is used to refer to routers.

1 In the IPv4 Setting menu, press  or  to select Default

Gateway.

2 Press [OK]. The Default Gateway screen appears.

3 Use the numeric keys or press  or  to set the default gateway.

You can set any value between 000 and 255.

Increase or reduce the figures by pressing  or .

Use  and  to move the position being entered, which is shown

highlighted.

4 Press [OK]. The default gateway is stored and the IPv4 Setting

menu reappears.

Note When you enter the subnet mask, be sure to set the DHCP setting to Off.

Subnet Mask:

/255.

255. 0. 0

Note Before you enter the gateway, be sure to set the DHCP setting to Off.

Default Gateway:

/**0.

0. 0. 0

1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 311 312

Sin comentarios

Utax P-4030DN Manual de usuario Pagina 117