
Technical Bulletin UTAX
CD 1430
TA DC 2430
TB 03 / Firmware Upgrade (V5.00)
SB-A162/M
Date: 27-05-2010
T
OPIC
:
The firmware was upgraded as follows.
C
ONTENT OF CHANGES
:
Contents Remarks
Preventing the both side edge
image drop-out when
receiving the FAX. (When
setting <Reduction priority>) *
* The factory default is
<100% magnification priority>
The both side edge image may drop-out because the received image is printed in the
real size on B5 size paper if the received data is of A4 width and length which is
undefined size in the sub scanning direction (its size is example) is printed on B5 size
paper.
This is corrected.
<Please refer to the next page. >
Measure against FAX receiving
to PORT2 when the service call
error appears
The FAX call may be received to Port2 depending on the timing (However, the line is
disconnected at once) when the service call error appears.
This is corrected so that the service start is not informed to the FAX board after the
service call error appears even if receiving the demand of the FAX service start. (This
does not occur in PORT1)
Support in Java API The address from header may not contain the E-mail address of login user when
sending E-mail in Java API. This is corrected.
Change of processing the
internal function in the sleep
mode
Standard OID hrPrinterStatus value is corrected in the sleep mode.
Change of the display timing
when the waste toner box is
FULL
JAM04 may occur if the front cover is opened before completing the job according to
the message that is displayed while printing in case the waste toner box FULL is
detected.
[Change]
This is corrected so that the error of the waste toner box FULL is not displayed while
printing.
MAIN FRAME
Support in KYOcontrol
Enterprise HyPAS application
KYOcontrol Enterprise HyPAS application may not function.
This is corrected.
1/2
Comentarios a estos manuales