
4-85
Using the Operation Panel
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
IPSec (IPSec setting)
IPSec (IP Security Protocol) is a security protocol adopted as the
standard by the IETF for authentication and encryption in the third
network layer (IP layer).
It can be used with both IPv4 and IPv6.
The default setting is Off.
1 After entering the administrator ID and password, press or
repeatedly until >IPSec appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using or .
4 Press [OK].
5 Press [Menu]. The display returns to Ready.
Thin Print (Thin Print setting)
Select whether or not to use ThinPrint.
1 After entering the administrator ID and password, press or
repeatedly until >ThinPrint > appears.
2 Press [OK]. A blinking question mark (?) appears.
3 Select On or Off using or .
4 Press [OK].
5 Press [MENU]. The display returns to Ready.
Note IPv4 uses 32-bit IP addresses and IPv6 uses 128-bit IP
addresses.
Note Check with your network administrator when selecting
network settings.
Comentarios a estos manuales